Ubiquiti Networks heeft versie 1.8.3 van de firmware voor de EdgeMax EdgeSwitches uitgebracht. De EdgeSwitches kenmerken zich door uitgebreide instelmogelijkheden, maar vergen wel enige netwerkkennis om het goed draaiend te krijgen. Ook zijn lang niet alle instellingen via de gui aan te passen en moet je dus via de commandline aan de gang. De lijst met veranderingen ziet er als volgt uit: Important notes Lite Version We provide new favorite EdgeSwitch firmware with the Lite suffix. This firmware limits the maximum VLAN count from 4093 to 255, reducing the memory utilization compared to the normal firmware version. If you have no requirement for 255 and more VLANs, you might consider using the Lite firmware. Note that the Lite firmware reduces the total VLAN count to 255, not the allowed VLAN ID range. Please check your configuration before you update to the Lite firmware version, as VLAN config will be lost if there are more than 255 defined VLANs. Memory re-tuning This memory re-tuning mechanism checks the flag from firmware version 1.8.2 and after. The device will reboot again and perform memory re-tuning when the flag does not exist. That means that the system will reboot one more time if you are first launching this firmware on the unit. Memory re-tuning might takes about ~5-10 minutes on some units. If your EdgeSwitch does not respond after 10 minutes, please power cycle the unit manually. Improvements
